The JetBoard Technology. Extensive Product Development to satisfy the highest expectations of JetBoarders World Wide.
Above: R Montgomery test riding the long Nose model in Asia, 2010.

Below: R Montgomery test riding the New Patented PowerSki JetBoard Short Nose Model 2010:
Above and Below: 2010 Bob Montgomery test riding production Short Nose Patented PowerSki JetBoard
Above: 2005 Bob Montgomery test riding his short nose prototype, Patented PowerSki JetBoard
The Engineering challenges and achievements, all jetboarders will appreciate, while riding the Patented PowerSki JetBoard.

There were five significant natural forces the engineering team had to deal with; weight, buoyancy, hydrodynamic lift, drag, thrust, and power. The PowerSki JetBoard™ combines a high thrust to weight ratio with a hull/rail design and center of gravity placement that stabilizes the craft at all speeds. The design also enables high-speed planing and high thrust "G-Force" turns with simple shifts in weight of a rear-mount.

There were many challenges in designing the patented production PowerSki JetBoard™

The challenges included the 4.5 foot patent bending flex gas tank which had to be installed into a 2.5 foot engine compartment with a reserve tank. Another design challenge was a high performance water cooled tuned exhaust system coupled with a one way valve water box silent system. This one way valve keeps the water from flowing into the engine at water level. The inflatable sealing system as used in F18's and sub-marines prevents water intrusion into the PowerSkiJetBoard™ engine compartment. The PowerSki JetBoard™ is 3/4 sub-marine when a rider sits on the PowerSki JetBoard™, and without the engine running it is almost 3/4 submerged under water. This design challenge was met with the PowerSki JetBoard™ state of the art inflatable sealing system. Oh, and not forgetting that we had to reshape the combustion engine to make the PowerSki JetBoard™ flat like a surf board to keep the low center of gravity for performance.

The PowerSki JetBoard™ design, endless wave. the ultimate ride for any type of jetboarder 

The PowerSki JetBoard™ puts the center of gravity under the rider's feet, rather than behind or in front of the ride-as is the case with similar sports water craft. Dual Hydrosteps on the bottom of the hull put the pivot point directly under the rider's feet, enabling high-speed planning and turning. The hydrosteps lift the craft partly out of the water as it skims along, and direct the line of water rushing past the rails during top speed turns, stabilizing the craft.

Bob Montgomery and his team not only designed a number board hulls, but also designed a series of engines to deliverer the power and performance of a God given dream.

The PowerSki JetBoard’s Patented Handle-JetBoarder's speed control

The Patented PowerSki Handle consists of the grip, start/stop buttons, thumb throttle, and safety kill switch. Sub-assemblies are attached to a four-foot long arm-pole consisting of steel cable and a sleeved wire harness covered by injection molded rubber that provides structural strength.

The grip is removable and replaceable. Scientifically engineered finger grooves to prevent hand and wrist fatigue are coated in cushy soft, textured sanitex/ saniprene rubber and nylon laid over a thermoplastic elastomer surface.